The new double-headed veneer cutter is a product that has undergone several improvements; It is a cutting tool powered by electric and pneumatic drills; It can cut metal sheets up to 2 mm (including steel, copper, aluminum, stainless steel board);When cutting a blunt cut for the other end to continue cutting, regardless of cutting cheeks or surfaces, can easily cut out a variety of straight lines, curves, arcs or other irregular lines and shapes.
When coupled with thin plate hole cutter can cut 55 mm -260 mm standard round hole;This product is light weight, small size, easy to operate and other characteristics, is an Perfect tool for auto repair, sheet metal production and new product development.
Operation requirements and replacement parts: knife blade diligent refueling, especially cutting aluminum is particularly important;first electric drill, after cutting, the end of the exit after the first off drill;Cutting cutter bar when the cut must be cut perpendicular to the workpiece to be cut, in case hard to break the broken head.
Arbor replacement: Open the protective cover, remove the locknut, loosen the set screw, remove the arbor with pliers, reinstall the arbor, and tighten the screws. Knife holder replacement: Screw out the compression cap counterclockwise, put on a new knife holder.
Sheet metal opener instructions
When equipped with a thin plate hole opener, first insert the front end of the drill and the cutter into the hole of the hole cutter, connect the cutter to the drill and lock it firmly, and then tighten the three sticks and the head screws of the rack , So as to prevent the hole of the hole opener from slipping. Insert the rule bar left-to-right into the square hole of the shelf with the left-to-right positioning pin upward.
Finally adjust and tighten the tight-top screw according to the size of the arc to be cut, In order to ensure the accuracy of cutting the hole.
Cut the standard arc, the sheet should be used to open the hole, in order to ensure that the arc smooth and beautiful section, should also work on the first drill a 3 mm positioning eye, and then drill a 12 mm hole, the bit into the hole Inside and outside the circle of cutting.
Specification:
Material: Alloy + Plastic
Color: Silver + Black
Diameter of the machine tool: 51 Diameter
Round speed: 1500- 3000rpm
Minimum cutting radius: 12mm
Compatible with: FITS ANY ELECTRIC DRILL
Maximum cutting thickness: steel plate 1.8mm, stainless steel 1.2mm.
copper/aluminium plate 2mm, plastic/fibreboard 2mm
Package Included:
1 x Machine tool
1 x Tool reset
1 x Cutter holder
1 x Hex key
1 x Plastic handle
Only the above package content, other products are not included.
Note:
Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.